Problem when deploying from CA-DSM
Hi,
I can install a Geomagic Software through command line by passing parameters like
/qn,Transforms,INSTDIR etc. It's works perfectly.
But when I put the same Script In CA DSM Packager & deploy it.I got the error
"Installation Source for the Product is not Available"
Please Advice.
Thank you.
Regards,
Abhishek
I can install a Geomagic Software through command line by passing parameters like
/qn,Transforms,INSTDIR etc. It's works perfectly.
But when I put the same Script In CA DSM Packager & deploy it.I got the error
"Installation Source for the Product is not Available"
Please Advice.
Thank you.
Regards,
Abhishek
0 Comments
[ + ] Show comments
Answers (1)
Please log in to answer
Posted by:
anonymous_9363
13 years ago
One, please delte your duplicate post.
Two, I suspect that you are trying to run the installation from a UNC or a network drive. Most deployment systems use the local System account to execute the installation. As you know, the System account has no network access. Re-configure the deployment to be copied locally first.
Two, I suspect that you are trying to run the installation from a UNC or a network drive. Most deployment systems use the local System account to execute the installation. As you know, the System account has no network access. Re-configure the deployment to be copied locally first.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.
