Ghost 8.0
Add your rating:
I am using Ghost 8.0 for the first time and every image I try to save to a supported CD-RW dirve. Then I restore the image on a different computer, it says imaged successful. Then I reboot and the OS never loads. Any Ideas? Thanks.
0 Comments
[ + ] Show comments
Answers (2)
Please log in to answer
Posted by:
cnull
20 years ago
Did you check to make sure that your OS partition is active(bootable). Use FDISK and check it out. Since you are using Ghost 8 you should check out BartsPE at http://nu2.nu/pebuilder/
Chris
Chris
Posted by:
cmattioli
20 years ago
It is set to active and it still will not boot I am using Universal Imaging Utility by the same company that made Ghost. I think will just go back to using sysprep alone.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.