Windows 10
I am having the hardest time imaging windows 10. I created a image and uploaded it into kace2000 when I go to deploy it works just fine. After the deployment when trying to boot the machine up I get an error stating "no boot device found". Using a brand new SSD in a micro 7050 what am I doing wrong here?
2 Comments
[ + ] Show comments
Answers (1)
Please log in to answer
Posted by:
Desktop Jockey
7 years ago
Ok then you are using a Legacy image.
The Below link will show you how to set up the partitions for a C/D configuration:
If I were you, I would look into altering your image so that the MBR resides on the Main (C) partition. But that is up to you.
Comments:
-
thanks i'll give that a try. - gerroe 7 years ago
UEFI or Legacy?
What partitions were harvested?
What Tasks are you using to partition and set the MBR? - Desktop Jockey 7 years ago
Create UEFI Partitions Assign D
Select disk 0
Clean
Convert gpt
Create partition efi size=200
Assign letter=s
Format quick fs=FAT32
Create partition msr size=128
Create partition primary
Assign letter=d
Format quick fs=NTFS
Exit
Format D as NTFS
format /q /y /s:enable /fs:ntfs d:
Install WinQO MBR (on D)
bootsect.exe /NT60 d:
That's as far as my "Pre-Installation Task". - gerroe 7 years ago
Please verify if this is UEFI or Legacy. You have some mis-matched commands going on right now. - Desktop Jockey 7 years ago