Disabling popup during shortcut launch for toad for db2 app.
Hello,
I am repackaging Toad for DB2 4.0.x.x. It is a vendor msi.
My msi runs in UI mode but it fails silently. What could be the possible reasons for it.
Also when I launch shortcut, A popup comes saying " A new version for this app is available. Would u like to go to download page?"
What is the registry entry to disable this popup?
Any help ????
I am repackaging Toad for DB2 4.0.x.x. It is a vendor msi.
My msi runs in UI mode but it fails silently. What could be the possible reasons for it.
Also when I launch shortcut, A popup comes saying " A new version for this app is available. Would u like to go to download page?"
What is the registry entry to disable this popup?
Any help ????
1 Comment
[ + ] Show comment
-
Hi, how did u disabled the pop-up which came during the shortcut launch?? Please help. - ankita_g29 11 years ago
Answers (2)
Please log in to answer
Posted by:
cygan
14 years ago
My msi runs in UI mode but it fails silently. What could be the possible reasons for it.
you have a custom action in the UI sequence that runs when you install in UI mode
make an entry for that CA in the installexecute sequence table for silent installation via an mst
regarding the pop up install your msi on a clean image ie (vm or ghost)
run a capture when you launch the shortcut to see what regkey is created
add regkeys via mst
self heal the keys if they are hkcu
Posted by:
kaushal019
14 years ago
Thanx a lot cygan for showing right direction . Application is working silenly as well now.
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.