How to Uninstall using setup.exe??
Hi all,
I have installed RoboHelp X5 on my system using setup.exe.
How can i uninstall the program using setup.exe? If i run it once again, it does not show the 'repair,remove' dialog. Instead, it just installs ovr the existing installation.
I have tried setup.exe /u /x, but in vain.
can anyone tell me how to uninstall this using setup.exe?
I have installed RoboHelp X5 on my system using setup.exe.
How can i uninstall the program using setup.exe? If i run it once again, it does not show the 'repair,remove' dialog. Instead, it just installs ovr the existing installation.
I have tried setup.exe /u /x, but in vain.
can anyone tell me how to uninstall this using setup.exe?
0 Comments
[ + ] Show comments
Answers (2)
Please log in to answer
Posted by:
Bladerun
19 years ago
Check this:
http://helpnet.installshield.com/robo/projects/InstallShieldxhelplib/IHelpSetup_EXECmdLine.htm#xParam
You may need to use /uninst.
http://helpnet.installshield.com/robo/projects/InstallShieldxhelplib/IHelpSetup_EXECmdLine.htm#xParam
You may need to use /uninst.
Posted by:
RoejbaekDK
19 years ago
Hello Vin..
You may use the uninstallstring in the registry:
"C:\Program Files\Common Files\InstallShield\Driver\8\Intel 32\IDriver.exe" /M{FA291352-8B46-4678-B344-C176F28C5C3E} anything
but it is not a silent uninstall...
Best Regards,
Christian Roejbaek
You may use the uninstallstring in the registry:
"C:\Program Files\Common Files\InstallShield\Driver\8\Intel 32\IDriver.exe" /M{FA291352-8B46-4678-B344-C176F28C5C3E} anything
but it is not a silent uninstall...
Best Regards,
Christian Roejbaek
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.