Error message when loading KBE_x86_33
We are currently trying to upload an image of an HP DC5100 (SFF) up to our VK2100 Deployment Appliance. However, after choosing "KBE_x86_33" from the boot menu, the pre-installation environment starts to load (as per normal), you see the Windows 7-style logo appear, then you simply get a Windows Error Message that says:
"Windows Failed to start."
"File: \windows'system32\config\system"
"Info: Windows failed to load because the system registry file is missing, or corrupt".
The issue is that it is only happening with this model computer (so far). All other models the KBE loads absolutely fine.
Any thoughts?
"Windows Failed to start."
"File: \windows'system32\config\system"
"Info: Windows failed to load because the system registry file is missing, or corrupt".
The issue is that it is only happening with this model computer (so far). All other models the KBE loads absolutely fine.
Any thoughts?
0 Comments
[ + ] Show comments
Answers (1)
Please log in to answer
Posted by:
scottlutz
13 years ago
I am going to assume what you have done is try to connect a machine to the K2000 that didn't have the correct drivers in the KBE.
It would be a good idea to:
1. Add the relevant drivers to your k2000 (http://www.kace.com/support/documentation/K2000-Adding-Drivers.pdf)
2. build a new boot environment as per the Admin Guide (http://www.kace.com/support/documentation/K2000-Admin-Guide-v3.3.pdf)
HTH,
Scott
It would be a good idea to:
1. Add the relevant drivers to your k2000 (http://www.kace.com/support/documentation/K2000-Adding-Drivers.pdf)
2. build a new boot environment as per the Admin Guide (http://www.kace.com/support/documentation/K2000-Admin-Guide-v3.3.pdf)
HTH,
Scott
Rating comments in this legacy AppDeploy message board thread won't reorder them,so that the conversation will remain readable.
