Detect and Deploy-completed but doesn't detect anything or deploy anything
This happens every single time and it finishes in two seconds, not sure where to start?
1 Comment
[ + ] Show comment
-
Does the account you have specified have the proper permissions to the destination path? - rockhead44 11 years ago
Answers (4)
Answer Summary:
Had to do with the server, I have a rep folder on our D:\ and I needed to share the folder
Had to do with the server, I have a rep folder on our D:\ and I needed to share the folder
Please log in to answer
Posted by:
dugullett
11 years ago
Do you have the patch labels applied, and have you verified that the patches have downloaded?
Posted by:
lsulax
11 years ago
yes, all patches are applied and downloaded. This only happens on remote machines using replication shares, when I enable failover it works.
Comments:
-
Sounds like the issue is with your rep shares then, not the patching setup itself. - nheyne 11 years ago
Posted by:
lsulax
11 years ago
it appears to be rep related, permissions are fine and the files are there
Comments:
-
When we set up our rep shares, we could see out from the share but not in because of a port being blocked. Could be something like that maybe? - nheyne 11 years ago
-
Yes make sure the file sharing ports are open. - petelanglois 11 years ago
-
Please remove the patching labels and recreate them. (this is a step which often solves the issue) If possible don't use them.
Also contact the support, to get a repl share patch.
It is possible that the patching DB on your replshares are too big, - Nico_K 11 years ago
Posted by:
lsulax
11 years ago
Had to do with the server, I have a rep folder on our D:\ and I needed to share the folder