How to deploy KACE Image with the C Partition as Recovery & D as where the main software is loaded
0 Comments
[ + ] Show comments
Answers (2)
Please log in to answer
Posted by:
mwill_27
11 years ago
LaurieAnn to complete this process, you will need to create a 2 partition and 2 format pre installation task for your K2000. Also in the image capture, be sure that you have both drives selected. Below, I have included a link that should assist you. THis link includes the pre installation tasks that needs to be added to you K2000 appliance.
Comments:
-
Use the article above for the diskpart commands, etc. However, if running 3.4, you don't have to switch the partitions anymore, that only applied to 3.3 or lower.
Corey
Lead L3 Enterprise Solutions Engineer, K2000
If my response was helpful, please rate it! - cserrins 11 years ago -
We used to have the older version of Kace pre-3.4, but now we are updated to 3.5
The Pre-tasks and post tasks are set to create the "Windows 7 - Create Two Partitions (3.1)", the "Windows 7 - Format Disks (3.1)" and the "Windows 7 - Two Partition BCD Fix (3.1)" as in the link above and we always do the diskpart step before capture and that works fine.
But the above link also says "All issues have been resolved in 3.4 and partitions do not need to be switched, but partitions still need to be created as they were captured"
So, I took that to mean the diskpart doesn't need to be done to swicth the partitions, but that doesn't work.
How do I capture the 2 partitions and what installation tasks are necessary to deploy the windows 100MB partition and the operating system partition properly in 3.5?
The hidden 100MB is captured as C by default and the operating system as D even though in the windows image there is just the C drive with the operating system.
Thanks. - Geoff25 11 years ago
